![]() This is needed for internal communication between splunkd and splunkweb. * If "true", it is mandatory to configure splunkd with same root CA in nf. * If "true", a client can connect ONLY if a certificate created by ourĬertificate authority was used on that client. Server has a certificate that was signed by the CA cert installed * Requires that any HTTPS client that connects to the Splunk Web HTTPS * If encrypted private key is used, do not enable client-authentication * Password that protects the private key specified by 'privKeyPath'. * Default: $SPLUNK_HOME/etc/auth/splunkweb/cert.pem * See also 'enableSplunkWebSSL' and 'privKeyPath'. They should be listed sequentially in the order: * The file may also contain root and intermediate certificates, if required. ![]() * Full path to the Privacy Enhanced Mail (PEM) format Splunk web server certificate file. * See also 'enableSplunkWebSSL' and 'serverCert'. * You can also specify an absolute path to an external key. * A relative path is interpreted relative to $SPLUNK_HOME and may not refer * The path to the file containing the web server SSL certificate private key. * Control if the Splunk Web client can override the client network location. * Values smaller than 30 will be ignored, resulting in the use of the * The amount of time, in seconds, to wait before timing out when communicating with Should be run in a legacy mode as a separate service, but as of * At one time, setting this to zero indicated that the web service Port numbers here and splunkd will start a load-balanced However you can provide a comma-separated list of For mostÄeployments a single application server won't be a performanceÄ«ottleneck. * Generally, you should only set one port number here. This port is bound only on the loopback interface - it is not * Port number(s) for the python-based application server to listen on. * Don't include " when specifying this setting. * The IP address and host port of the splunkd process. * If using SSL, set to the HTTPS port number. ![]() ![]() * If omitted or 0 the server will NOT start an http listener. * Must be present for Splunk Web to start. * The TCP port on which Splunk Web listens for incoming connections. * Set whether or not to start Splunk Web. * If you do not specify an entry for each setting, Splunk Web uses the * Follow this stanza name with any number of the following setting/value * Set general Splunk Web configuration options under this stanza name. # To learn more about configuration files (including precedence) please see You must restart Splunk software to enable # configurations, place a web.conf in $SPLUNK_HOME/etc/system/local/. # There is a web.conf in $SPLUNK_HOME/etc/system/default/. # This file contains possible attributes and values you can use to configure The following are the spec and example files for web.conf. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |